MK Diamond MK-212 - Manual (Page 33)

33
MK-212 SAW MAINTENANCE
CUTTING HEAD DOES NOT MOVE CORRECTLY
(B)
Lubricate the Guide Rail and
Cutting Head.
(A)
Check that Guide Rail and Cutting
Head is clean and clean if dirty.
(C)
Check the Cutting Head
alignment.
BLADE STOPS TURNING
(B)
Verify all plugs are fully connected.
(A)
Check the ON/OFF Switch is in
the ON position.
(C)
Check to see if the Ground Fault
Circuit Interrupter (GFCI) tripped.
(E)
Verify circuit breaker not tripped; if
it is tripped, reset it once only.
(D)
Verify the circuit breaker is at least
20 amps – if not, move to 20 amp
circuit.
(F)
Check power source voltage
is 115v – if not 115v, move to
another circuit.