MK Diamond MK-212 - Manual (Page 30)

30
(A)
Remove the Blade Guard.
(C)
Loosen the two Beam Post Cutting
Head Pivot Knobs located on each
end of the saw.
(B)
Using a combination square,
check the Blade for vertical
alignment.
CUTTING HEAD ALIGNMENT
(E)
Using a combination square,
check the Blade for 45° alignment.
(D)
Pivot the Beam and retighten the
two Pivot Knobs.
(F)
Loosen the four Guide Rail
Adjusting Screws using a
1/2-inch socket.
MK-212 SAW MAINTENANCE
(G)
Adjust the Guide Rail until it
is aligned both vertically and
horizontally.
(H)
Tighten the four Guide Rail
Adjusting Screws using a
1/2-inch socket.
NOTE: The alignment of the Cutting Head should be checked periodically to ensure the
accuracy of the cut.