MK Diamond MK-212 - Manual (Page 23)

23
MK-212 SAW OPERATION
OFF-ANGLE CUTTING
NOTE: To cut angles other than 90º, a Protractor (MK Diamond Part No. -159572) should be used.
(C)
Set the desired Cutting Angle and
tighten the Retaining Knob.
(A)
Remove the adjustable Rip Guide.
(B)
Place the Protractor on the side
of the cutting table. Adjust the
Protractor to fit the tile being cut
and tighten the Retaining Knobs
to lock the Protractor.
(D)
Position the tile against the
Protractor and the Stop.
(E)
Verify the tile is seated against the
Stop and Protractor and that the
desired angle is correct.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
CAUTION
(F)
Turn the motor ON.
(G)
Verify proper cooling flow on both
sides of the blade.
(H)
Perform the cut.
(I)
Turn the motor OFF when work
is complete.