Caution – MK Diamond MK-212 User Manual
Page 22
22
ANGLE CUTTING
NOTE: To cut at an angle, the MK-212 has been designed with a pivoting cutting head.
(C)
Position the adjustable Rip Guide to
desired cut length. Use a Square to check
alignment of the Back Stop to the Blade.
(A)
Loosen the two Beam Post Cutting
Head Pivot Knobs located on each
end of the saw.
(B)
Pivot the Cutting Head and
retighten the two Pivot Knobs.
(D)
Place the tile against the Back
Stop and Rip Guide. Verify the tile
is seated against the Back Stop
and Rip Guide.
MK-212 SAW
OPERATION
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
CAUTION
(E)
Turn the motor ON.
(F)
Verify proper cooling flow on both
sides of the blade.
(G)
Perform the cut.
(H)
Turn the motor OFF when work
is complete.