MTS 709 Alignment System - Manual (Page 150)

709 Alignment System
Changing the FieldPoint IP Address Sub-Net
Appendix 150
Changing the FieldPoint IP Address Sub-Net
Typically there should be no need to change the FieldPoint IP Address Sub-Net.
One possible exception is use in a server network with a different sub-net than
the default. In this case the FieldPoint should be set up and configured with the
Peer To Peer connection according to the instructions, then change the sub-net:
1. Start NI Measurement & Automation Explore and do not exit until
completing all steps.
2. Change the FieldPoint IP Address (follow instructions on page 53).
3. Apply the change (follow instructions on page 54).
4. Wait for FieldPoint to reboot.
5. Change the NIC IP Address (follow instructions on page 47).
6. Wait until NI Measurement & Automation Explore can sample data again
(see page 57).
7. Save the FieldPoint setting as a new IAK file name using new IP address.