Target strain, Specimen parameters – MTS 709 Alignment System User Manual
Page 78
Advertising
709 Alignment System
Specimen
78
Target Strain
This field shows the value of the target strain defined by the Target Class
selection. This is also the value of the target area on the graph displayed on the
Align tab.
Specimen Parameters
The values in these fields are entered by the user and define the alignment
specimen. The specimen dimensions available (Specimen Diameter, Rectangular
Width, Distance to Edge) are determined by the cross section type of the
specimen. The Axial Boundary is explained in a following paragraph; see
“Axial
Boundary”
on page 79.
The other specimen parameters in the grayed fields and calculated values based
on the user entered values for the specimen above.
Advertising