Get specimen offset values, Get specimen offset values 87 – MTS 709 Alignment System User Manual
Page 87
Advertising
Get Specimen Offset Values
709 Alignment System
Specimen Offsets
87
Get Specimen Offset Values
Note
It is recommended that the load unit be aligned prior to setting the
specimen offset values. In order to get an accurate specimen offset
reference, the load unit should first be aligned.
A typical sequence to get the specimen offset values would be:
1. Start the 709 Alignment program.
A.
Select the Align tab.
B.
Click Specimen Offsets.
A
B
Advertising