MTS 709 Alignment System - Manual (Page 53)

Software Installation
709 Alignment System Installation 53
Note If the FieldPoint has already been configured, you can skip to step 4.
2. Set up the IP address.
A. Expand the Remote System selection (double click or click the +).
Note If there is a warning icon ( ) next to the FieldPoint device, it indicates a
communication problem. If the Local Area Connection (on page 40)
status shows enabled (i.e. no red X) then see
“Resetting the FP-20xx” on
page 146 in the Appendix section for additional information
B. Expand 0.0.0.0.
C. Ensure the Network Settings tab is selected.
D. Enter IP address 10.0.0.101.
Enabled Disabled
B
A
C
D