Brother BES-1261BC - Manual (Page 126)

Chapter 6 Operation of Machine
BES-961BC • BES-1261BC 124
• If "area over" is displayed, press the check
switch. The hoop automatically moves inside
the embroidering area, where the pattern is
set, at the nearest position.
0.1mm
0.1mm
Embroidering area
(Example)
Embroidering
start position
6. Area Check
6-1 External Tracing
• If the check switch is pressed in other cases
than "area over", the rectangular outline of the
pattern is traced.
6-2 Automatic Hoop Movement in Area
Note) After finishing the movement inside the area by this function, execute external tracing. Then, check that the needle
and the presser foot do not interfere with the hoop before starting embroidering.
Embroidering area
If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the area. Enlarge
the embroidering area on the operation panel.