Brother BES-1261BC - Manual (Page 44)

Chapter 1 Preparation of Embroidery Machine
BES-961BC • BES-1261BC 42
6. Check that the clearance between the Y-axis cover
u
and the mounted holder base frames L
e
and R
t
is even when viewed from the right and left sides.
[Adjustment] Loosen the right and left bolts of the F table guide U
i
and move it in the direction of arrow for
adjustment.
7. Tighten each bolt securely after adjustment is finished.
Attaching the holder base
1. Mount the holder base mounting frame
e
on the X-axis feed frame
q
and holder base frame
C
w
, using three clamp screws.
2. When the mounting pitch of the holder base is 370 mm, mount the holder base horizontally to
the holder base mounting frames
e
using the thumb bolts
r
.
w
e
r
q