Brother BES-1261BC - Manual (Page 26)

Chapter 1 Preparation of Embroidery Machine
BES-961BC • BES-1261BC 24
3-3 Preparation of Needle Bar Case
■ BES-961BC
1. Loosen the bolt
q
, and move the needle case
w
to the left.
2. Press the change bracket collar
r
against the change case base
e
on the light, while pressing
the change bracket collar
t
against the change case base
y
on the left, and tighten the bolt
q
. Check that needles at needle bar No.1 and 9 are inserted into the needle plate holes
smoothly.
Note) • Check that the connecting shaft u does not have backlash in the horizontal direction.
• If the bolt i of the change bracket collar on the right is loosened, it may be dislocated during adjust-
ment of the needle bar case w . Do not loosen this bolt.
r
q
u
w
e
t
y i