Other editing, 0 stitch deletion – Brother BES-1261BC User Manual
Page 88
BES-961BC • BES-1261BC
86
Chapter 4 Editing of Embroidering Data
Other Editing
Setting of other functions related to editing is available.
The following types of setting is available.
0 stitch deletion
For deleting stitches at the same point without
stepping forward or back.
This function is previously set to
(for not deleting
0stitch)upon shipment.
For deleting 0 stitch
For not deleting 0 stitch
Thread trimming feed number
For setting the number of feeds for thread trimming
This function is previously set to
(ECS data)
or
(Except ECS data)upon shipment.
For thread trimming at every 3 feeds
For thread trimming at every 5 feeds
For thread trimming at every 8 feeds
For not thread trimming
Swing width correction
For setting the needle swing width correction amount
The correction amount can be set in increments of 0.1mm.
The setting range is 0 ~ 1.0mm in both the X and Y
directions. (The setting range is displayed as "0 ~
10" on the screen.)
Compensation is reflected only on the satin-stitched
section.
This function is previously set to 0(no swing width
correction)upon shipment.
1.
Read sewing data.
2.
Press
three times.
0 Stitch Deletion
3.
Select this function by pressing .
4.
Press
E N D
after setting is finished.
Press when setting continuously.