Brother BES-1261BC - Manual (Page 156)

BES-961BC • BES-1261BC 154
Chapter 9 List of Error Codes
Power supply frequency error
No power error
Lower shaft flash memory error
Lower shaft version-up error
Area over during embroidering
Wiper out error
Presser foot down error
Main(Z) motor speed error
Cylinder bed position error
Power PCB error
Cooling fan motor stop
Power voltage upper limit error
Power voltage lower limit error
X-axis pulse motor overcurrent stop
Turn off the power
Y-axis pulse motor overcurrent stop
Turn off the power
Exhaust fan motor stop
Hook motor error
Turn the power off once, then on again. If the same
error occurs again, the power PC board or power supply
is faulty.
Press
STOP
.
Turn the power off once, then on again. If the same
error occurs, the main PC board is faulty.
Press
STOP
and clear the error display and upgrade the
version again.
Set the embroidering area again.
If the wiper is tangled with a thread, remove it. Then
press
STOP
.
Press
STOP
.
Press
STOP
and clear the error display. Then press
S T A R T
.
If the same error occurs again, there is a possibility that
the spindle is overloaded.
Secure to bed.
Turn the power off once, then on again. If the same
error occurs again, the power PC board is faulty.
Turn the power off. Check that the fan on the left or bottom
rear of the control box is not tangled with a harness, etc.
before turning the power on again. If the same error occurs
again, the fan or the power PC board is faulty.
Press
STOP
. If the same error occurs again, the power
PC board or the power supply is faulty.
Turn the power off once, then on again. If the same
error occurs again, the pulse motor or the main PC
board is faulty.
Press
STOP
. If "OFF" is displayed, turn the power off.
Check that the fan at the right rear of the control box is
not tangled with a harness, etc. before turning the
power on again. If the same error occurs again, the fan
or the power PC board is faulty.
Finish the test mode or turn the power OFF once, then
ON again. If the same error occurs again, the main PC
board is faulty.
E-BA
E-BC
E-BD
E-BE
E-C1
E-C2
E-C4
E-CB
E-CE
E-D0
E-D1
E-D2
E-D3
E-E1
E-E2
E-E3
E-E4
Code Error Measures