Re-open previous project, Figure 31 - installation, Figure 32 – Weidmuller WI-I/O-9-U2: Wireless Mesh I/O & Gateway User Manual V1.2.2 User Manual
Page 52: Configuration software
Advertising
51
Figure 31 - Installation
Figure 32
– Configuration Software
When the Confiugration Utility has been installed and run you are presented with 3
options,
1. Re-Open Previous Project,
2. Open Exisitng Project,
3. Create New Project.
Re-Open Previous Project
When selected, this will open the last used project on this PC. Typically all configuration
project files are stored locally on the used PC or a Network drive. Below the button is
the path to the last used project.
Advertising