Weidmuller WI-I/O-9-U2: Wireless Mesh I/O & Gateway User Manual V1.2.2 - Manual (Page 90)

89
Product Reconfiguration
Changes the operating mode between WIBMesh and WIBNet.
WIBNet is a compatibility mode that will allow communications between the WI-I/O 9-U2
and earlier WEIDMULLER WI-Series Telemetry units, e.g. WI-I/O 9-X-1, 2, 3, 4, C, G,
K, L, etc.
Figure 79 - Product Reconfiguration
The Dropdown box has two selections,
Meshing Mode - Standard Weidmuller WIBMesh and is the format that the module will
be in when it arrives from the factory.
Legacy Compatibility Mode – WI-Series compatibility mode, will allow communications
with WEIDMULLER WI-Series modules Wireless I/O modules
To change from one to the other select the appropriate mode and then press ‘Set” and
then ‘Reset Unit’ when prompted.
Module will then reset and when complete will be in the selected mode.
Note: WIBMesh is the default operational mode when setup in the factory.
.