Weidmuller WI-I/O-9-U2: Wireless Mesh I/O & Gateway User Manual V1.2.2 - Manual (Page 85)

84
Figure 70 – Mesh Fixed Route#2 Routing Rules
The first route shows the destination and next addresses are both 10.0.0.1 as it’s a
single hop. Because the destination is a Gateway on an external network the IP
Gateway must be enabled.
The second routing rules shows the Destination (192.168.1.100) is an external network
and is outside of the radio mesh, therefore the External tick box must be enabled. The
next address will be 10.0.0.1, which is the IP Gateway.
Mesh Fixed Routing Rules
Name A name that describes the routing rule (Max 32 characters).
Destination
The destination network or Host IP address. You can specify a
whole network by entering the IP range 192.168.0.0 with a Netmask
of 255.255.255.0 or specify an individual host IP address.
Next
Specifies the IP address of the next hop router for the specified
destination. Next is the same as destination for the final hop. Next is
the same as destination for one-hop routes.
Hops Indicates the number of routing hops to the destination.
IP Gateway Indicates the Destination acts as a gateway out of the mesh
External Indicates that it is routed through a Gateway outside of the mesh
Enabled
Check this box to enable the rule. You can Uncheck the box to
disable a routing rule without needing to re-enter the information at
a later time.
Save Changes
and Activate.
Save changes to non-volatile memory, and restarting the function to
load new configuration.