Weidmuller WI-I/O-9-U2: Wireless Mesh I/O & Gateway User Manual V1.2.2 - Manual (Page 84)

83
The Mesh fixed Routes for Rep Site #2 are shown above.
The first entry shows the communication path back to Site #1 so the Destination IP and
Next Address are configured with the address 10.0.0.1 (Site #1).
As Site #2 is a repeater for site #4 the second route shows the Destinations being Site
#4 with a next address of Site #3.
The Mesh Fixed Route configurations for the other remote modems will have similar
routeing rules however the configuration will reflect the required communication paths.
After configuring all the remote sites we can check the communications paths by
selecting the ‘Network Diagnostics’ Web page and entering in the destination address in
the Remote IP Address and pressing the ‘TraceRoute’ button.
You will see in the screenshot below the TraceRoute for the Remote Address 10.0.0.4
(Site #54) is communicating via 10.0.0.2 (site #2) and 10.0.0.3 Site #3)
Example #2
Figure 69 - Mesh Fixed Route#2
Figure 67 - Mesh Fixed Route - Rep Site #2
Figure 68 - Trace Route