Rockwell Automation 56AMXN/B ControlLogix AutoMax Comm Module - Manual (Page 9)

AutoMax DCSNet/RE RIO Module Page 9
Publication number 56AMXN-UM002A-EN-P November 2002
Hardware Features
The following diagram shows the features of the module.
NET OK CLX
DCSNet / RE RIO
XXXX
Network
The module has:
• A label to indicate that it is a scanner for AutoMax DCS and remote
I/O
• A 4-character scrolling display (XXXX)
• 3 LEDs, labelled NET, CLX, and OK, to indicate the status of the
network, the connection to the ControlLogix processor, and its own
internal state
• a 9-pin D-shell connector to connect to the DCS or remote I/O
network
• switches at the top of the module to set the mode of operation and
the drop number and drop depth
The module hardware consists of:
• Processor – 100MHz IDT MIPS
• FLASH memory - 1Mbyte (512Kx16)
• Local RAM - 1Mbyte (256Kx32) 50Mhz synchronous SRAM
• Shared RAM - 512Kbyte (128Kx32) 20ns asynchronous SRAM
Other Requirements
To use the configuration or monitor programs, you require RSLinx OEM
or above. You cannot use RSLinx Lite.
To use multiple connections, you need RSLogix 5000 version 12.00 or
above.