Rockwell Automation 937CU-AISTR-DC1 Strain Gauge Converter Installation Instructions - Manual (Page 10)

8
WARNING: A change in device data will change the operation of the device!
WARNING: Before entering new data into the device, you should therefore as certain that no danger to the
installation will result.
FDT Interface
This manual describes Parameterization mode of the universal frequency converter using the control panel. parameterization mode
for the universal frequency converter is more convenient with a PC using
Field Device Tool (FDT) software.
Some specialized functions can only be selected using the
FDT , for instance, pulse suppression as an alternative to the start-up
override.
The FDT interface is the specification describing the standardized data exchange between devices and control system or engineering
or asset management tools. Examples include: PACTware
TM
, FieldCare, FactoryTalk
AssetCentre, and Process Device Configuration.
FDT frame software can be downloaded from the web: www.pactware.com
www.fdtgroup.org.
PACTware TM is trademark of PACTware Consortium
Bul. 937
C Strain Gauge Converter Installation Instructions
Messages during operation
• Alarm freeze
• Hold on error
Error messages
• Err INT: error in the internal communication of the Strain Gauge Converters; may also occur if no
sensor is connected
• Err MEM: error in the memory of the Strain Gauge Converters
• Err SIM: Strain Gauge Converter in simulation mode (only when using FDT.
• Err CELL: cell breakage or no cell connected; for information on selecting the check for sensor
breakage
If you cannot solve the problem by checking the cell and the cell cables and by switching the Strain
Gauge Converters off/on, please contact Rockwell Automation.
In the case of a fault, the relays switch into a state with no current, unless you have selected the
function Hold on error .
Editing device data