Rockwell Automation 937CU-AISTR-DC1 Strain Gauge Converter Installation Instructions - Manual (Page 37)

Service
The following figure shows the menus for the service parameters. The menu options of the lowest
menu level are surrounded by a bold box.
RS
485: Set the address of the Strain Gauge Converter for communication via the RS 485
interface here.
Reset: If yes is flashing and you press the OK key, all settings of the
Strain Gauge Converter will be
reset to factory settings (see exceptions: language and password activation). All entries which you
have ever made in parameterisation mode and the adjust will be lost.
Service ——
Password
—— On
Off
Language —— Eng (English)
De (German)
RS 485 (see below) —— 0 to 31
Reset (see below.) —— yes
no
Bul. 937
C Strain Gauge Converter Installation Instructions
35