Rockwell Automation 1397 DC Drive Firmware 2.xx User Manual
Page 184
5–74
Programming Parameters
Publication 1397-5.0 — June, 2001
MASKS
[Logic Mask] — P.207
This parameter determines which adapters
can control the drive. If the bit for an adapter
is set to “0”, the adapter will have no control
functions except for stop. In addition, the
adapter can be removed from the drive while
power is applied without causing a serial
fault.
Display/Drive Units:
Numeric/Text
Parameter Range:
Bit # Enum Text
0 = Terminal Block
1 = Adapter 1
2 = Adapter 2
3 = Adapter 3
4 = Adapter 4
5 = Adapter 5
6 = Adapter 6
Parameter Type:
Tunable
Group:
Masks or through Control Logic
Minimum Value:
0000000000000000
Factory Default:
0000000001111111
Maximum Value:
0000000001111111
[Local Mask] — P.208
This parameter controls which adapters are
allowed to take exclusive control of drive logic
commands (except stop). Exclusive “Local
Control” can only be taken while the drive is
stopped.
Display/Drive Units:
Numeric/Text
Parameter Range:
Bit # Enum Text
0 = Terminal Block
1 = Adapter 1
2 = Adapter 2
3 = Adapter 3
4 = Adapter 4
5 = Adapter 5
6 = Adapter 6
Parameter Type:
Read & Write
Group:
Masks
Minimum Value:
0000000000000000
Factory Default:
0000000001111111
Maximum Value:
0000000001111111