2 - installation, Prevent electrical shock, Chapter 2 – Rockwell Automation 1760-xxxx Pico Controller User Manual User Manual
Page 25: Installation, Prevent electrical shock -1, Chapter
Advertising
1
Publication 1760-UM001D-EN-P - September 2005
Chapter
2
Installation
Pico is installed in the following order:
• connect devices together, if necessary
• Mount
• Use surge suppressors
• Wire the inputs
• Wire the outputs
• Connect incoming power
Prevent Electrical Shock
ATTENTION
Follow these guidelines when you handle the
controller:
• Remove power before working on any of the
wiring to Pico.
• Touch a grounded object to discharge static
potential.
• Wear an approved wrist-strap grounding device.
• If available, use a static-safe work station.
Advertising