Connect the expansion module, Mount the pico controller – Rockwell Automation 1760-xxxx Pico Controller User Manual User Manual
Page 27
Advertising
Publication 1760-UM001D-EN-P - September 2005
Installation 2-3
Connect the Expansion
Module
Connect the expansion module to the controller using the connector
as shown below:
See Expansion Modules on page 1-4 for information on using the
modules with your Pico controller.
Mount the Pico Controller
Install Pico in an enclosure, switch cabinet, or distribution board so
that the power feed and terminal connections cannot be touched
accidentally during operation.
Clip Pico onto a DIN rail or install directly onto a panel using the
mounting feet. Pico can be mounted either vertically or horizontally.
2
1
TIP
When using a Pico expansion module, connect the
expansion module and Pico controller together
before mounting. See Connect the Expansion
Module.
Advertising