Rockwell Automation 1760-xxxx Pico Controller User Manual - Manual (Page 46)

Publication 1760-UM001D-EN-P - September 2005
2-22 Installation
Connect Outputs The Q output terminals function as isolated contacts, as shown below.
Outputs are controlled via the corresponding output relays:
• Q1 to Q4
• Q1 to Q8
• S1 to S6
• S1 to S8
You can use the signal states of the output relays as make or break
contacts in the Pico program to provide additional logic conditions.
The relay or transistor outputs are used to switch loads such as
fluorescent tubes, filament bulbs, contactors, relays or motors. Check
the technical thresholds and output data before installing such devices
(see Relay Outputs on page A-10).
Connect Relay Outputs 1760-L12AWA-xx, 1760-L12BWB-xx and 1760-L12DWD
.
Q1
Q1
1 2
Q1
0 V , N
< 8 A / B 16
L1, L2, L3 (120/240V)
+ 24 V
25.000
R L
24 V 8 A
120 V 8 A
240 V
8 A
2 A
2 A
2 A
1000 W
10 x 58 W
1 2 1 2 1 2 1 2
10 000 000
Q1 Q2 Q3 Q4