Rockwell Automation 1760-xxxx Pico Controller User Manual - Manual (Page 87)

Publication 1760-UM001D-EN-P - September 2005
Draw a Circuit Diagram with Pico 4-27
Parameter Display and Parameter Set for a Timing Relay
In the parameter display of a timing relay you can change the mode,
the time base, the time setpoint 1, time setpoint 2 (if necessary) and
the enable of the parameter display.
Compatibility Between Pico Series A and Pico Series B Controllers
New functions have been added to the parameter display of the Pico
Series B Controllers. The Series A parameters can be found at the
following points:
T1 Timing relay number 1
X On-delayed mode
S Time range in seconds
+
• + appears in the Parameter menu
• - does not appear in the Parameter menu
I1 Time setpoint 1:
• Positive value, I7, I8, I11, I12
• Actual value T1 to T16, C1 to C16
I2 Time setpoint 2:
• Positive value, I7, I8, I11, I12
• Actual value T1 to T16, C1 to C16
T: Display of actual value in Run mode
T1 X S +
00.000 I1
00.000 I2
T:
AA.BB
TRG
RES
X
S
{
T1
T1 X S +
AA.BB I1
I2
T:
T1 X S +
10.000 I1
00.000
03.305
I2
T:
Pico Series A
Mode, time base
Time setpoint 1
Time setpoint 2
Actual value of elapsed time
Contact has not switched
Contact has switched
AA.BB
TRG
RES
X
S
{ T1
T1 X S +
AA.BB I1
I2
T:
Pico Series A Pico Series B
T1 = T1
X = X
S = S
AA.BB = AA.BB
+ = +