Importing the processlogix server points database – Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide User Manual
Page 100
Publication 1757-IN040B-EN-P - March 2002
4-10 ProcessLogix Server Upgrade Procedures
Importing the ProcessLogix Server Points Database
1. Logon to the system as ps_user.
2. Click Start
⇒
Run.
3. Key in this command in the Open entry field:
>cmd<
and click OK to open the DOS window.
4. At the DOS prompt, key in the following command:
>hscserver /stop /y<
and press Enter.
5. After Completed successfully, key in the following command:
>hscserver /unload /y<
and press Enter.
6. To copy the points database, key in the following command:
>Copy C:\Honeywell\server\data.upgrade\points C:\Honeywell\server\data<
7. Press Enter.
8. To start the ProcessLogix Database, key in the following
command:
hscserver /load /y
and press Enter.
9. To import the data, key in the following command:
>sysbld -restore C:\Honeywell\server\data.upgrade\data -default -y<
ATTENTION
!
For Redundant systems, these steps are performed
on the SERVERA node, with the SERVERB node
shut off.