Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 63)

Publication 1757-IN040B-EN-P - March 2002
Operating System Installation Procedures 2-37
Setting Up Additional Drivers after the Service Pack Installation
Use the following procedure to set up the display driver.
1. Click Start
⇒
Settings
⇒
Control Panel.
2. Double-click the Display icon.
3. Click the Settings tab.
4. Set the Desktop Area to 1024 by 768 pixels.
5. Set Color Palette to 65536 Colors.
6. Set Font Size to Small Fonts.
7. Set the Refresh Frequency to the maximum Hz that the monitor
can handle.
ATTENTION
!
If your particular video card is not detected (only a
VGA card is detected), you need to install drivers
provided by the PC manufacturer. You can do this
after Windows NT is installed through the Control
Panel application.
1. Click Start
⇒
Settings
⇒
Control Panel.
2. Double-click the Display icon.
3. Click the Settings tab.
4. Click Display Type.
5. Click Change and follow the dialog box
instructions.
If you installed a new driver, restart the PC and
complete your NT logon. NT automatically detects
the new driver and opens Control Panel so you can
change the settings.