Rockwell Automation 1772-LV,D17726.6.1 A and I MNL MINI-PLC-2/15 PROCESSO - Manual (Page 34)

Assembly and Installation
Chapter 3
3Ć14
Install one lithium batter in the front battery compartment, seam side down,
with the polarity shown in Figure 3-15.
Reconnect the 3-pin connector at the base of the Battery Pack.
When the batteries are installed, slide the Battery Pack onto the tracks and
tighten the thumbscrew.
Figure 3.12
Switch Group Settings
1 2 3 4 5 6 7 8
O
N
O
F
F
No Significance
ON: Outputs remain in last state when
Fault is detected.
OFF: Outputs deĆenergized when Fault
is detected.
ON
OFF
ON
Side View
10119ĆI