Black Box LRU4240 - Manual (Page 154)

142 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
configure terminal
Use the configure terminal command to change to configure terminal mode.
Command Syntax: configure terminal
Command Mode: Enable
Usage
There are no arguments or keywords for this command. The prompt will change to
Unit(config)#
Example
Unit(enable)#configure terminal
Unit(config)#
quit
Use the quit command to change exit from the current mode and return to the higher level mode.
Command Syntax: quit
Example
Unit(config)#quit
Unit(enable)#
show running-config
Use the show running-config command to show running config.
Command Syntax
show running-config
Command Mode: unit
There are no arguments or keywords for this command.
Examples
Unit(enable)#show running-config
show running-config
Use the show running-config command to show running config.
Command Syntax
show running-config
Command Mode: rip
There are no arguments or keywords for this command.
Examples
Rip(enable)#show running-config
43: Current configuration:
44: !
45: !
46: !traffic configuration
47: traffic type ppp
48: multilink no
49: traffic monitoring disabled
50: ip route mode routing
51: !
52: !unit configuration
53: unit protect-mode disabled
54: unit yellow-alarm disabled
55: unit clock primary net1
56: unit clock secondary int
57: unit remote-comm none
58: unit ansi-fdl enabled
59: unit monitor-jack net1
60: !
61: !net configuration
62: t1 framing net1 esf
63: t1 lbo net1 0db
....
show unit id
Use the show unit id command to show the 6 characters local unit identifier.
Command Syntax
show unit id
Command Mode: unit