Black Box LRU4240 - Manual (Page 187)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 175
ospfd(config)# interface fxp0
ospfd(config-if)# ip ospf priority 3 10.10.10.50
Related Commands
ip ospf network, neighbor
Equivalent Commands
ospf priority
ip ospf retransmit-interval
Use the ip ospf retransmit-internal command to specify the time between link-state advertisement (LSA) retransmissions for
adjacencies belonging to the interface.
Use the no form of this command to return to the default value.
Command Syntax
ip ospf retransmit-interval INTERVAL (A.B.C.D)
no ip ospf retransmit-interval (A.B.C.D)
INTERVAL= <3-65535> Specifies the time in seconds between retransmissions. Default interval value is 5
seconds.
A.B.C.D = IP address of the interface.
Command Mode
Interface mode
Usage
After sending an LSA to a neighbor, the router keeps the LSA until it receives an acknowledgement. In case the router does not
receive an acknowledgement during the set time (the retransmit interval value) it retransmits the LSA.
Set the retransmission interval value conservatively to avoid needless retransmission. The interval should be greater than the
expected round-trip delay between two routers.
Examples
The following example shows setting the ospf retransmit interval to 6 seconds on the fxp0 interface for IP address 10.10.10.50.
ospfd# configure terminal
ospfd(config)# interface fxp0
ospfd(config-if)# ip ospf ospf retransmit-interval 6 10.10.10.50
Related Commands
ip ospf transmit-delay
Use the ip ospf transmit-delay command to set the estimated time it takes to transmit a link-state-update packet on the interface.
Use the no form of this command to return to the default value.
Command Syntax
ip ospf transmit-delay DELAY (A.B.C.D)
no ip ospf transmit-delay (A.B.C.D)
DELAY= <1-65535> Specifies the time taken, in seconds, to transmit a link-state-update. The default
transmit delay value is 1 second.
A.B.C.D = IP address of the interface.
Command Mode
Interface mode
Usage
The transmit delay value adds a specified time to the age field of an update. If the delay is not added, the time in which the LSA
transmits over the link is not considered. This command is especially useful for low speed links. Add transmission and propagation
delays when setting the transmit delay value.
Examples
The following example shows setting the OSPF transmit delay time to 3 seconds on the fxp0 interface for IP address 10.10.10.50.
ospfd# configure terminal
ospfd(config)# interface fxp0
ospfd(config-if)# ip ospf transmit-delay 3 10.10.10.50
Equivalent Commands
ospf transmit-delay