Black Box LRU4240 - Manual (Page 39)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 27
Using the Ethernet port as management interface
As an alternative to managing the Dual Trunk E1 Router via the COMM port, you can manage it
directly using the Ethernet port (ENET). You can then Telnet into the device from any workstation
in the network. This provides for both local and remote access.
Using Terminal Software
Once you have attached the Dual Trunk E1 Router to a terminal using one of the methods described
above, you will need to use terminal emulation software to communicate with, and configure the
device. You may use Hyperterm Windows, or the terminal emulation software of your choice. If
using Hyperterm, follow the instructions outlined below to set up and run the program.
Terminal Setup
The COMM Port factory default settings on your device are defined as:
• Baud Rate — 38400
• Parity Bit — none
• Word Length — 8
• Stop Bits — 2
Make sure that your terminal software is set to work with these parameters, or use the front panel to
alter the default settings. Once you are logged in, the unit’s COMM port settings may be changed as
shown in the section
“Adjusting COMM Port Settings” on page 31 . In addition, the following
parameters should be set:
• Hardware Flow Control––none
• Terminal Emulation––VT-100
Hyperterm Windows Setup
Hypterterm is a Windows terminal emulation program that can be used to log on to the unit.
1. Run Hypertrm.exe.