Black Box LRU4240 - Manual (Page 209)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 197
10.10.11.51 1 Full/DR 00:00:38 10.10.11.10 hme1:10.10.11.50 0 0 0
ospfd#
ospfd# show ip ospf neighbor detail
Neighbor 10.10.11.51, interface address 10.10.10.10
In the area 0.0.0.0 via interface hme0
Neighbor priority is 1, State is Full, 6 state changes
DR is 10.10.10.10, BDR is 10.10.10.50
Options 66 *|O|-|-|-|-|E|-
Dead timer due in 00:00:32
Database Summary List 0
Link State Request List 0
Link State Retransmission List 0
Thread Inactivity Timer on
Thread Database Description Retransmision off
Thread Link State Request Retransmission off
Thread Link State Update Retransmission on
Neighbor 10.10.11.51, interface address 10.10.11.10
In the area 0.0.0.0 via interface hme1
Neighbor priority is 1, State is Full, 6 state changes
DR is 10.10.11.10, BDR is 10.10.11.50
Options 66 *|O|-|-|-|-|E|-
Dead timer due in 00:00:32
Database Summary List 0
Link State Request List 0
Link State Retransmission List 0
Thread Inactivity Timer on
Thread Database Description Retransmision off
Thread Link State Request Retransmission off
Thread Link State Update Retransmission on
Neighbor 10.10.11.51, interface address 10.10.11.10
In the area 0.0.0.0 via interface hme1
Neighbor priority is 1, State is Full, 6 state changes
DR is 10.10.11.10, BDR is 10.10.11.50
Options 66 *|O|-|-|-|-|E|-
Dead timer due in 00:00:32
Database Summary List 0
Link State Request List 0
Link State Retransmission List 0
Thread Inactivity Timer on
Thread Database Description Retransmision off
Thread Link State Request Retransmission off
Thread Link State Update Retransmission on
Examples
ospfd# show ip ospf neighbor detail
ospfd# show ip ospf neighbor 1.2.3.4
ospfd# show ip ospf neighbor myifname detail all
Related Commands
show ip ospf route
Use the show ip ospf route command to display the OSPF routing table. Include the process ID parameter with this command to
display the OSPF routing table for specified instances.
Command Syntax
show ip ospf route
show ip ospf PROCESSID route
PROCESSID = <0-65535> The ID of the router process for which information will be displayed. If this
parameter is included, only the information for this specified routing process is displayed.
Command Mode
Priviledged Exec mode
Usage
The following are sample outputs from the show ip ospf route command with and without the process ID parameter. Notice that
the first output (without process ID), shows information about both the instances and the second and third outputs show
information only about the instances specified by the process ID.
ospfd# show ip ospf route
OSPF process 100:
============ OSPF network routing table ============
N 10.10.10.0/24 [10] area: 0.0.0.0
directly attached to eth1