Black Box LRU4240 - Manual (Page 181)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 169
ospfd# no debug ospf zebos redistribute
Related Commands
terminal monitor, log file
default-information originate
Use the default-information originate command to create a default external route into an OSPF routing domain.
Use the no form of this command to disable this feature.
Command Syntax
default-information originate (ALWAYS|METRIC|ROUTE)
no default-information originate
ALWAYS = always (METRIC|ROUTE) Used to advertise the default route regardless of whether the
software has a default route.
METRIC = [METRIC METRIC-TYPE]|[METRIC-TYPE METRIC]
METRIC= metric <1-16777214> (ROUTE)
metric Sets the OSPF metric used in creating the default route. The default metric value is 10. The
value used is specific to the protocol.
METRIC-TYPE= metric-type 1|2 (ROUTE)
metric-type Sets the OSPF external link type for default routes.
1 Sets OSPF External Type 1 metrics.
2 Sets OSPF External Type 2 metrics.
ROUTE= route-map WORD
WORD= Specifies the name of route-map.
Command Mode
Router mode
Usage
The system acts like an Autonomous System Boundary Router (ASBR) when you use the default-informationoriginate command
to redistribute routes into an OSPF routing domain. An ASBR does not by default, generate a default route into the OSPF routing
domain.
When you use the default-information originate command, also specify the route-map map-name option to avoid a dependency on
the default network in the routing table.
The metric-type is an external link type associated with the default route advertised into the OSPF routing domain. The value of
the external route could be either Type 1 or 2; the default is the Type 2.
Examples
ospfd# configure terminal
ospfd(config)# router ospf 100
ospfd(config-router)# default-information originate always metric 23 metric-type
2 route-map myinfo
Related Commands
default-metric
Use the default-metric command to set default metric values for the OSPF routing protocol.
Use the no form of this command to return to the default state.
Command Syntax
default-metric <1-16777214>
no default-metric
<1-16777214> Default metric value appropriate for the specified routing protocol.
Default
Built-in, automatic metric translations, as appropriate for each routing protocol.
Command Mode
Router mode
Usage
A default metric facilitates redistributing routes even with incompatible metrics. If the metrics do not convert, the default metric
provides an alternative and enables the redistribution to continue. Default-metric command is used to cause the current routing