Black Box LRU4240 - Manual (Page 45)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 33
Access Configuration 4
O
VERVIEW OF
A
CCESS
C
ONFIGURATION
This chapter contains information about configuring the LAN and WAN interfaces, the interface IP
addresses, NMS IP addresses, Radius authentication, DHCP, and miscellanous management settings
Table 4-1 Access configuration procedures
Procedure Description Menu Reference
Configuring LAN
interface To set or modify the Ethernet data port IP address and subnet mask,
and the ethernet speed (10MB/Half or 10MB/Full). Menu-0A
Menu-0C page 35
Setting Unit ID, Date,
Time, and E1 Network To configure the network E1 timing, framing, and coding. Menu-4A
Menu-4B page 35
Allocating Timeslot for
data and voice To allocate and map fractional dual E1 bandwidth to the Ethernet data
port Menu-6Z page 37
Configuring WAN
protocol To configure the WAN protocol to:
• Single link PPP interface
• Dual independent PPP link interfaces
• Multilink PPP (MLPPP) interface
• Single link Frame Relay interface
• Dual links Frame Relay interfaces
• Multilink Frame Relay (MFR) interface
Menu-0A page 38
Configuring Frame Relay
DLCIs To configure statically the DLCI numbers with associated interface. Menu-0E page 40
Configuring Link
Management Information To enable or disable LMI, and configure LMI settings, unit location
UNIT-U or UNI-N Menu-0F page 40
Mapping DLCIs to IP
addresses To configure the mapping of DLCI to the next hop IP addresses
statically and manually. Menu-$IA page 41
Configuring SLIP To configure SLIP (Serial Line Interface Protocol) to allow telnet
access through the COMM port. Menu-0A page 41
Configuring Access
Rights To set the TUI normal and superuser access levels. Menu-8C page 42
Configuring Radius
Authentication To configure Radius authentication, user login and password,
preventing unauthorized access and changes to the access router TUI. Menu-8G page 42
Enabling/Disabling Traffic
Monitoring (Optional) To enable or disable the router from collecting and reporting RMON-1,
and RMON-2 statistics.
To enable or disable Frame Relay SLA and configure Frame Relay
SLA statistics.
By default Traffic monitoring is disabled. Menu-0A
Menu-0H
page 44