Black Box LRU4240 - Manual (Page 162)

150 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
traffic type
Use the traffic command to set the WAN protocol to Frame Relay or PPP.
Command Syntax:
traffic type [frame-relay | ppp]
unit alarm
Use the unit alarm command to configure the network alams that will be generated to the NMS.
Command Syntax:
unit alarm inband-lonk-loss [enabled | disabled]
unit alarm interface [net | aux] [carrier-loss | sync-loss | ais-received | yellow-received] [enabled | disabled]
unit alarm interface enet carrier-loss [enabled | disabled]
unit ansi-fdl
Use the unit ansi-fdl command to enable or disable standard remote monitoring ansi-fdl.
Command Syntax:
unit ansi-fdl [enabled | disabled]
unit clock
Use the unit clock command to configure the primary and secondary clock.
Command Syntax:
unit clock primary [net | net1| net2 | aux | internal]
unit clock secondary [net | net1| net2 | aux | internal]
unit comm-port
Use the unit comm-port command to configure the console port and flow control.
mand Syntax:
unit comm-port baud [9600 | 14400 | 19200 | 28800 | 38400]
unit comm-port dcd [enabled | disabled]
unit comm-port parity [none | odd | even]
unit comm-port stop-bits [1 | 2]
unit comm-port word-length [7-8]
unit comm-port xon-xoff [disabled | xoff-until-xon | xoff-unti-any]
unit id
Use the unit id command to set the unit identifier
Command Syntax:
unit id [HOSTNAME]
unit idle-code
Use the unit idle-code command to set the idle code.
Command Syntax:
unit idle-code [0-ff]
unit management
Use the unit management command to configure the dial out management feature.
Command Syntax:
unit management connection [direct | fdl | modem]
unit management connection-timeout-logged-on [unlimited | 1-minute | 10-minutes | 30-minutes]
unit management connection-timeout-not-logged-on [unlimited | 1-minute | 10-minutes | 30-minutes]
unit management dial-out-time [0-255]
unit management phone1 WORD
unit management phone2 WORD