Black Box LRU4240 - Manual (Page 189)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 177
match metric
Use the match metric command to match the specified metric value. Use the no parameter to turn off the matching.
Command Syntax
(no) match metric METRICVALUE
METRICVALUE = <0-16777216>
Default
Disabled
Command Mode
Route-map mode
Usage
To set the conditions for redistributing routes from one routing protocol to another, use the match and set route-mapconfiguration
commands. The match commands specify the match criteria under which redistribution is allowed for the current route-map. The
set commands specify the set redistribution actions to be performed, if the match criteria are met.
If a route does not match the criteria completely, it will not be advertised for outbound route maps and neither be accepted for
inbound route maps. You can modify the data by configuring a second route-map section and specifying an explicit match.
Some types of LSAs have specific metric values.Use the match metric command to match metric value.
Examples
ospfd# configure terminal
ospfd(config)# route-map mymap1 permit 10
ospfd(config-route-map)# match metric 100
Related Commands
match tag, match route-type external
match route-type external
Use the match route-type external command to match specified external route type. Use the no parameter to turn off the matching.
Command Syntax
(no) match route-type external (type-1 | type-2)
Default
Disabled
Command Mode
Route-map mode
Usage
To set the conditions for redistributing routes from one routing protocol to another, use the match and set route-mapconfiguration
commands. The match commands specify the match criteria under which redistribution is allowed for the current route-map. The
set commands specify the set redistribution actions to be performed, if the match criteria are met.
If a route does not match the criteria completely, it will not be advertised for outbound route maps and neither be accepted for
inbound route maps. You can modify the data by configuring a second route map section and specifying an explicit match.
Use the match route-type external command to match specific external route types. AS-external LSA is either Type-1 or Type-2.
External type-1 matches only Type 1 external routes and external type-2 matches only Type 2 external routes.
Examples
ospfd# configure terminal
ospfd(config)# route-map mymap1 permit 10
ospfd(config-route-map)# match route-type external type-1
Related Commands
match tag, match route-type external
match tag
Use the match tag command to match the specified tag value. Use the no parameter to turn off the declaration. Tag is
the route tag which is labeled by another routing protocol (BGP or other IGP when redistributing).
Command Syntax
(no) match tag <0-4294967295>
Default
Disabled