Black Box LRU4240 - Manual (Page 160)

148 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
ip route vlan-id
Use the ip route vlan-id to set the unit management VLAN ID. With the default VLAN ID disabled, set to 9999, the unit will
check every VLAN frame for management traffic by matching the destination IP address with the unit IP address, which is the
Ethernet port IP address. By setting a unit VLAN ID, the unit will first match VLAN ID in VLAN frames, then match the
destination IP address with the unit IP address. This limits management traffic to a specific VLAN and reduces the processor load.
Command Syntax:
ip route vlan-id <0-4093>
Set the VLAN ID for management traffic.
Command Mode: Config
Example
ip route vlan-priority
Use the ip route vlan-priority to set the unit VLAN priority field so that it can be managed in VLAN bridging mode.
Management traffic is identified with unit VLAN ID and destination MAC address.
Command Syntax:
ip route vlan-priority <0-7>
Set the VLAN Priority field.
Command Mode: Config
Example
ip static-route clear
Use the ip static-route clear to clear the static routing table.
Command Syntax:
ip static-route clear
Command Mode: Config
multilink
Use the multilink command to enable multilink PPP or multilink Frame Relay and configure the multilink protocol parameters.
Command Syntax:
multilink [yes | no
yes ]
multilink mfr
Use the multilink mfr command to configure multilink Frame Relay protocol parameters.
Command Syntax:
link-ack [1-10]
link-integrity-timer [1-180]
retry-counter [1-5]
multilink mlppp
Use the multilink mlppp command to configure multilink PPP protocol parameters.
Command Syntax:
keep-alive-timeout [1-10]
keep-alive-timer [1-180]
retry-counter [1-5]
t1 framing
Use the t1 framing command to configure the network T1 framing format.
Command Syntax: t1 framing [net1 | net2] [esf | d4]
Command Mode: Config
Example
unit(config)#t1 framing net1 esf