Rockwell Automation 1747-KFC15 SLC500 CONTROLNET RS-232 USER MANUAL - Manual (Page 19)

1747-5.34 - June 1998
Chapter
2
Configuring the KFC15 Module
Use this chapter to configure the KFC15 communication parameters
via the DIP switches and rotary switches on the module.
Overview of Configuration Procedures
The KFC15 module is configured by using the DIP and rotary
switches located on the module. These two types of switches
configure the RS-232 serial communication parameters, and the
network address. During configuration, the module must not be
powered. Once the switches are set, the module can then be installed
in the SLC chassis. Located on the front of the KFC module is a dot
matrix display, which you can use to verify your settings. Refer to
Chapter 5 for more information on the dot matrix display.
Refer to Chapter 4 for information on configuring the communication
between the SLC500 and the KFC15 modules.