Rockwell Automation 1747-KFC15 SLC500 CONTROLNET RS-232 USER MANUAL - Manual (Page 32)

4-4 Communicating with the KFC15 Module
1747-5.34 - June 1998
6. Select the Auto-Configure pushbutton to obtain the serial parameters.
Once you have confirmed the communication settings for the SLC500,
you can use the dot matrix display on the KFC15 to verify the settings are
the same. Refer to Chapter 5 for information on interpreting the display.
If you are unsure, you can check the three DIP switch banks on the
KFC15 module for the particular settings.
Related Publications
Listed below are publications you can reference for information about
RSLogix500 and RSLinx.
• Getting Results with RSNetworks for ControlNet -
pub. no. 9399-CNETGR
• Getting Results with RSLogix500 with RSNetworks for ControlNet -
pub. no. 9399-RWCNPGR
• Getting Results with RSLogix500 - pub. no. 9399-RL50GR
• Getting Results with RSLinx - pub. no. 9399-WAB32GR