Rockwell Automation 1747-KFC15 SLC500 CONTROLNET RS-232 USER MANUAL - Manual (Page 25)

1784-5.34 - June 1998
Chapter
3
Installing the KFC15 Module
Use this chapter to install the KFC15 module. This chapter describes:
• an overview of the general installation procedure
• how to connect the KFC15 module to your SLC500 processor
through the RS-232C serial port
• how to connect the KFC15 module to a host through the isolated
network access port (NAP)
• how to connect the KFC15 module to the ControlNet network
Pinout and wiring details are provided in Appendix B, Cabling and
Pinouts. Read this if you need to construct cables. If a tap is not
available on the ControlNet network for the KFC15 module, refer to
the ControlNet Cable System Planning and Installation Manual
(pub. no. 1786-6.2.1) to determine if your cable system can
accommodate another node and to plan where to mount the tap, then
follow the mounting instructions at the end of this chapter.
If you have attempted to install the KFC15 module and still have
questions, please call Rockwell Automation Technical Support at
(440) 646-6800.