Rockwell Automation 1794-IE4XOE2,1794-IE8,1794-OE4,D17946.5.2 FLEX I/O ANALOG MODULE - Manual (Page 14)

Chapter
2
Publication 1794Ć6.5.2 - May 1996
How to Install Your
Analog Module
In this chapter, we tell you about:
•
how to install your module
•
how to set the module keyswitch
•
how to wire the terminal base
•
the indicators
Before installing your analog module in the I/O chassis:
You need to: As described under:
Calculate the power requirements of all
modules in each chassis.
Power Requirements, page 2-2
Position the keyswitch on the terminal base Installing the Module, page 2-4
!
ATTENTION: +24V dc power must be applied to
your module before operation. If power is not applied,
the module position will appear to the adapter as an
empty slot in your chassis. If the adapter does not
recognize your module after installation is completed,
cycle power to the adapter.
If this product has the CE mark it is approved for installation within
the European Union and EEA regions. It has been designed and
tested to meet the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards,
in whole or in part, documented in a technical construction file:
•
EN 50081-2EMC – Generic Emission Standard, Part 2 –
Industrial Environment
•
EN 50082-2EMC – Generic Immunity Standard, Part 2 –
Industrial Environment
This product is intended for use in an industrial environment.
Chapter Objectives
Before You Install Your
Analog Module
Compliance to
European Union Directives