Rockwell Automation 1784-KTCS ControlNET Scanner Installation Instructions - Manual (Page 15)

ControlNet Scanner Card 15
Publication 1784-5.35 – April 1999
Installing the Card
Important: Before you install the card, make sure you know how to configure
the computer’s options, e.g., disabling cache memory, memory
manager, and shadowing of memory, and that you know how to
install hardware in your computer. Consult your computer’s
documentation for specific information.
To install the card, you need to:
•
access the computer’s expansion slots
You need a Phillips-head or a flat-head screwdriver, depending on your
system.
•
insert the card into the computer
Accessing the Computer’s Expansion Slots
To install the card, you must access the computer’s expansion slots. Follow
these general steps, or refer to your computer’s user guide for more explicit
instructions.
1. Power down the host computer by turning off the power switch.
2. Remove the computer’s cover.
3. Select a vacant 16- or 32-bit expansion slot.
Important: The card will function only in a 16- or 32-bit ISA/EISA
expansion slot.
4. Remove the slot’s expansion cover by loosening the screw on the back
(rear bracket) of the computer.