Rockwell Automation 1784-KTCS ControlNET Scanner Installation Instructions - Manual (Page 16)

16 ControlNet Scanner Card
Publication 1784-5.35 – April 1999
Inserting the Card
To insert the card inside the computer:
1. Follow the card handling instructions on page 4.
2. Make sure you have correctly set all of the switches on the card.
3. Insert the card into the edge connector and tighten the expansion slot screw.
4. Turn on the computer to make sure it powers up correctly.
If the computer: then:
powers up go to step 5
does not power up correctly you probably have a memory or I/O conflict
You should
• change switch settings and cycle power, or
• remove all other cards and try again
If you are still unsuccessful, contact your local
Rockwell Automation sales representative or
distributor, or Rockwell Automation Technical
Support at (440) 646-6800.
5. Replace the CPU cover (when computer powers up correctly).
Installing IOLinx Software
Important: IOLinx software requires Microsoft Windows NT 4.0 or later.
Follow these steps to install the IOLinx software.
1. Insert the CD in the CD-ROM drive.
Important: We strongly recommend that you exit all Windows
programs before running this Setup program.