Rockwell Automation 1784-KTCS ControlNET Scanner Installation Instructions - Manual (Page 4)

4 ControlNet Scanner Card
Publication 1784-5.35 – April 1999
ATTENTION: This digital apparatus does not exceed the Class A
limits for radio noise emissions from digital apparatus set out in the
Radio Interference Regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la class A
prescrites dans le Règlement sur le brouillage radioélectrique édicté par
le ministère des Communications du Canada.
Handling the Card
ATTENTION: The card uses CMOS technology, which is highly
sensitive to electrostatic discharge (ESD). ESD may be present
whenever you are handling the card. Handling a card without any ESD
protection can cause internal circuit damage that may not be apparent
during installation or initial use.
Take these precautions to guard against ESD damage:
•
Before handling the card, be sure to touch a grounded object such as a PC’s
metal chassis to discharge any built-up static charge.
•
Avoid touching the backplane connector or interface connector pins located
on the card.
•
If the card is not in use, store it in the anti-static clamshell that the card was
shipped in.
Important: Remember, a computer with ac power disconnected is not a
grounded object.
You are now ready to configure your card.