Rockwell Automation 1784-KTCS ControlNET Scanner Installation Instructions - Manual (Page 22)

22 ControlNet Scanner Card
Publication 1784-5.35 – April 1999
Figure 3
KTCS card connector
1784KTCS
Network Access Port (NAP)
RJ-45 connector for connecting programming
terminals to devices on a ControlNet network
Channel A
BNC connectors for connecting directly to a
ControlNet network
Channel B
Redundant media
BNC connectors
Diagnostic status
indicators
A
B
TIP: The light icon is channel A;
the dark icon is channel B.
ATTENTION: Do not use the card to connect to more than one
network at a time. Attempting to connect to a second network will
cause your communication system to operate erratically.
See page 26 for information about status indicators. Indicators diagnose only
redundant media BNC connections.
Important: If you are using a non-redundant cabling system, all ControlNet
devices must be on the same channel, channel A.