Rockwell Automation 1784-KTCS ControlNET Scanner Installation Instructions - Manual (Page 20)

20 ControlNet Scanner Card
Publication 1784-5.35 – April 1999
4. Select the I/O Base Address for this card.
Refer to Worksheet E on page 11. You
recorded your I/O base address there.
Important: Make sure that the card is not
connected to a ControlNet network.
5. Click Next to continue.
The wizard prepares to locate the card at the I/O address you defined. If you
have installed multiple cards, the check wizard can be run for each card by
entering a different I/O address each time.
6. Click Next to continue.
The wizard attempts to locate your 1784-KTCS card at the specified I/O
address.
When the wizard locates your card, it displays Card has been found, and:
DualPort address where the card was found
Bootcode version
serial number
main code version
7. Click Next to continue.
The wizard attempts to put the KTCS card in the online state.
Important: Make sure that the KTCS card is not connected to a
ControlNet network.
8. Click Next to continue.
You see the message: Going Online.
9. Click Next to continue.
You see the message: Online State Reached.