Rockwell Automation 2706-P42R_P42C_P43R_P43C_P44R_P44C_P72CNx_P74CNx InView Marquee Message Display - Manual (Page 11)

Publication 2706-IN006E-EN-P
10 InView Marquee Message Display
Stacking
1. Remove the top screw from each end cap of the bottom sign, as
shown in Step 1 of the Ceiling Mounting instructions on page 9.
2. Using the screw removed in Step 1, screw a stacking bracket to
each end cap, countersunk side out. Torque to 2.7 Nm (24
in-lb).
3. Remove the top and bottom screws from each end of the
remaining signs.
4. For each end of the signs, secure the stacking bracket from the
bottom sign to the next sign using one of the screws removed in
Step 3. Torque to 2.7 Nm (24 in-lb).
5. Secure a ceiling bracket to the top of each end cap on the top
sign, using Step 2 of the Ceiling Mounting instructions on page 9.
TIP
Up to 4 signs can be hung together vertically
(“stacked”). Mounting system for stack mounting
must support a minimum of four times the total
weight of all signs being stacked.
WARNING
!
Possible crush hazard. Do not stack more than 4
signs. Otherwise signs may fall causing serious injury
or death.
Stacking
bracket
Screw
Remove
these
screws.
Stacking bracket
Bottom sign
Next sign
Ceiling
bracket
Top sign
Stacking
bracket