Rockwell Automation 2706-P42R_P42C_P43R_P43C_P44R_P44C_P72CNx_P74CNx InView Marquee Message Display User Manual
Page 15
Publication 2706-IN006E-EN-P
14 InView Marquee Message Display
2. Feed electrical cable through 1” water-tight conduit, the outside
end of the connector (supplied), the electrical opening in the
sign case, and then through the inside end of the connector.
Screw the inside and outside ends of the connector together
until water-tight.
3. Strip the electrical wires back 1/4”. Connect the wires by screwing the
end of each wire into the power connection.
Quarter-turn latches
on an 2706-P74 sign
Front view,
closed
Front view, open
Power
connection
Serial
connection
Power supply
Power line
filter
Serial
device
opening
Electrical
opening
Right-end
view
Electrical opening
Front view
Sign case,
inside
Conduit
Connector,
outside end
Connector nut, with teeth
facing the sign case
Rubber gasket