Rockwell Automation 2755 AdaptaScan Bar Code Readers - Manual (Page 43)

Installing the Wiring Base and Power Supply 3–8
The mounting bracket kit (Catalog No. 2755-NM42) is suitable for a
variety of applications. This bracket allows you to mount the Reader
at just about any angle or degree of rotation.
Kit Contents
The mounting bracket kit contains:
•
Adjustable mounting bracket
•
Mounting plate
•
Safety wire
•
Two hex socket screws
•
Hex bolt
!
ATTENTION: Install the safety wire when the
bracket is mounted in an inverted position. If the
bracket is mounted inverted and the locking knob is
loosened, the Reader could release from the bracket
and cause personal injury or damage to the Reader.
Installing the Mounting Bracket
The mounting bracket is attached to a mounting surface using three
screws (1/4 inch or M6).
ЙЙЙЙЙЙЙЙЙ
ЙЙЙЙЙЙЙЙЙ
Mounting Surface
The mounting holes for the bracket consist of 3 holes spaced 120
_
apart on a 4 5/16 inch (109.54 mm) diameter pattern.
120
_ 120
_
4-5/16 inch (109.54 mm)
Diameter Bolt Pattern
3 Bolt Holes
120 _ Apart
Mounting Bracket