Rockwell Automation 2755 AdaptaScan Bar Code Readers - Manual (Page 44)

Installing the Wiring Base and Power Supply 3–9
Top Post Mounting
The mounting plate attaches to the bottom of the wiring base with
three screws (see next page). The mounting bracket post is threaded
into the hole at the center of the mounting plate. Lock the mounting
post in position by tightening the locking knob. For additional
security, you can remove the locking knob and replace it with the hex
bolt provided. The two hex socket screws are not used in this
configuration.
Mounting Plate to Reader Screws
Mounting Plate
Mounting Post
Adjustable Mounting Bracket
(Hardware Provided with Base)
Bracket Locking Knob or
Bolt (5/16 x 1 inch)
See Side Mounting Illustration Next Page
Screws Into Mounting Plate
Adjustable Mounting Bracket
Wiring Base
3 Mounting Holes